SSP’s
Specifications subject to change without notice: Revision date 10/07 Page 239 of 266
SSP Data Entry
1. Procedures:
1) Place the SRV key to the SRV-Mode position
2) Enter the following sequence:
XXX: Line No. Data
MRS = None
Notes: The 1
st
Line No entered represents the SSP #.
The contents of the SSP Data entry are printed on the Receipt and Journal.
If a “CHECK SUM ERROR” message is printed after the depression of the [CASH]
key, it will be necessary to review the contents against the provided bulletin and
reenter the specific line no. data which is not been previously entered correctly by
the following procedure outline for SRV Job#991 (next page).
IMPORTANT: A SERVICE RESET (Program Reset) is mandatory in order for the SSP data
to take effect.
To Next Page
Loading...
