ER-A520/A530 Dealer Knowledge Book
Page 242 of 266 Specifications subject to change without notice: Revision date 10/07
Additional SSP Setting Procedures:
1. SRV-Mode SSP Report Print
To print the contents of the SSP data follow the key sequence outlined below:
@
CA/AT
990
Important:
Compare the printed receipt with the technical bulletin when a “CHECKSUM ERROR” is printed upon
depression of the [CA/AT] key
2. SRV-Mode SSP Error Correction
If there is an error you may correct the data by following the sequence outlined below:
@
CA/AT
991
.
SBTL
Step of Wrong
Data
@
Right Data
Important:
Upon depression of the [CA/AT] key verify that the “CHECKSUM ERROR” is not printed. If so, then re-verify
the data against what has been printed and once the wrong data is identified, repeat the error correction
procedure
NOTE:
A PROGRAM RESET is mandatory after the SSP data entry for the modification to have an effect.
3. SRV-Mode SSP Deletion
In case it is necessary to delete all entered SSR data to correct wrongful data entered, please follow the
procedure below:
@
CA/AT
992
.
To Next Page
Loading...
