Cleaning and Maintenance
1. After wash course ends, turn off the water tap, shut the power off. Remove water
inlet hose if necessary.
2. Please drain the tub completely. Make sure the tub is dry and there is no water
residue.
3. Unplug the washer before maintenance.
4. Hang the hose and power cord properly.
5. Use a soft cloth to wipe away the water and stain inside the tub, open the lid for 1
hour then close the lid back.
6. Use a soft cloth to clean the water and stain on the washer body. To avoid damage
to the body, do not use detergents, solvents , etc.
Maintenance
Cleaning Lint Filter
Cleaning Water Inlet
1. Shut off the
water faucet,
lift the hose
up.
2. Switch power on,
press Water Level
button.
3. Press Start/Pause
button.
Caution: Switch
power off after few
seconds.
5. Clean the inlet
valve filter.
Caution: The filter
can be removed and
washed.
4. Remove water inlet
hose.
Caution: Do not twist
the hose.
After long usage time, water inlet filter may be blocked by dirt. Please follow instructions below to clean the filter:
1. Detach the filter from the
washing machine.
2. Remove the net from the filter and
turn it inside out. Clean the net with
clean water and restore it to the filter.
3. Attach the filter back into
the washing machine.
Proper care of your washer can extend its life.
12
Clean it at least once a week.
water inlet valve
本机
附件清单
17
洗涤剂盒
螺钉
洗涤液
投放盒
洗衣粉
投放盒
柔顺剂
投放盒
To Next Page
Loading...
