1. Slowly lean the unit facing up/down on soft object.
2. Push the bottom cover into the base slot.
3. Use the screw to fix the bottom cover onto the base
of body (a small hole in the middle of the
bottom cover), then slowly lift up the unit.
How to Install
Installing the bottom cover
1. Install the washer, adjust the Adjustable Feet if
surface is not level. The distance between the
tub and cabinet should be the same (left & right,
front & back).
2. Distance between washer and wall should be at
least 5cm.
Placing the washer
Connect the drain hose to drain outlet, then secure
it with the metal clamp.
1. Do not seal the drain hose in the sewer pipe
to avoid poor drainage or no drainage.
2. In case of extending the drain hose, do not
exceed 3m to avoid long drainage time.
3. The height of the drain hose should not be
more than 10cm.
Installing the drain hose
Installing the water inlet hose
1. The joint of water inlet hose consists
of 2 parts, adapter and collar.
2. Pull down the collar of the inlet hose
to remove the adapter.
3. Loosen connectors A and B.
1. Length of the faucet need to be at least 10mm, outer diameter need to be 24mm and below.
2. If a suitable faucet is installed, an adapter is not necessary to be installed.
3. Spout of faucet should be smooth and round.
4. If spout of faucet is not flat, scrape it with rasp until it is flat.
5. Remove liner if outer diameter of faucet is too big.
5
Note
Note
Do not place washer on stage to avoid overturn. When placing washer on carpet, make sure
carpet does not block air vents.
front/back
back/front
soft object
bottom cover
Distance between
dehydration tub and
cabinet should be same
adjustable
feet
metal clamp
adapter
adapter
adapter
collar
collar
loop
nut
screw
about 5mm
liner
dehydration tub
cabinet
24
注意
桶洗净操作方式
按压“电源”键接通电源后，按压“附加”键直至桶
洗净灯点亮，按压“启动/暂停”键洗衣机开始工作。
TUB
CLEAN
To Next Page
Loading...
