Sharp ESX156 - Control Panel Functions; How To Use Different Washing Programs; Standard Program; Heavy Program

POWER:
CAUTION:
START/PAUSE:
*STANDARD:
HEAVY:
GENTLE:
QUICK WASH:
SOAK:
WASH:
RINSE:
SPIN:
SAFETY LOCK:
Plug the power cord, press this buon, the power will be connected. Press this
buon again to shut the power off.
1. Press POWER buon to acvate power, it will turn off automacally aer 5
minutes of inacvity.
2. Press START/PAUSE buon when machine operates, it will turn off
automacally aer 10 minutes of inacvity.
Connect power and press this buon, the chosen program will start running.
Press again, chosen program will pause.
Default program, suitable for daily soiled clothing like shirt and pants.
Strong washing flow, suitable for towel and other heavy clothing.
Suitable for silk or other delicate clothing.
Low water level, suitable for less dirty or light clothing.
An addional washing program, only suitable for STANDARD and HEAVY mode.
Aer selecng, SOAK will light up together with the chosen program. Display
shows “JP”. When soaking, tub rotates disconnually. Soaking me sets
automacally according to water level, manual seng is not available. Soaking
me for water level LOW and E.LOW:20 minutes; water level HIGH and MID:30
minutes.
Select for wash program.
Select for rinse program.
Select for spin program.
All buons will not funcon under safety lock mode, except to unlock. Alarm
beeps when lid is open under safety lock mode. For safety purpose, washer will
drain the water if lid opens for too long.
This funcon is to wash the inner tub, do not put any clothes when you
acvate this funcon. For beer cleaning result, you may add detergent
for cleaning tub.
Control Panel Functions
Control Panel
7 22
WATER LEVEL:
PRESET:
Choose the suitable water level according to load size. (E.LOW~HIGH)
Select suitable preset me (1~24 hours).
Preset me is to decide when to start washing. If the schedule me is set 1 hour,
program will start washing aer 1 hour. PRESET is an addional funcon on top
of other features.
TUB
CLEA N
TUB CLEAN:
1.无水位调节功能。
2.自动设置为高水位。
注意
*Power on, press PROGRAM buon for 3 seconds (there will be a sound of “beep”, water level will be in HIGH).
Then press START to enter Water Efficiency mode. This nominated mode is recommended for normally soiled load equal
to the rated capacity in the product literature.
・Fuzzy program starts display with “- -“
・When program is running, display shows remaining me (Rem) in “minute”
・When PRESET mode operang, display shows preset me (Preset) in “hour”
・When SOAK mode operang, display shows “JP”
・When error occurs, display shows error code, see page 13