Timer Operations
102
Timer Operations
The Timer function allows you to set up an operation to be performed
automatically at a specified time. Up to 48 operations can be set at any
one time, and the time of each can be set up to a week in advance.
You can use this function to take advantage of lower off-peak rates
without having to be there when the operation is performed.
Note: The DOCUMENT key cannot be used for a timer transmission.
Initial procedure
To set a timer operation, first perform the following procedure. After
you have completed this procedure, go to the procedure for the
specific operation you want to set (see the following pages).
1
Press the TIMER key.
The display will show:
2
Press 1 to select SET.
TIMER MODE
1=SET, 2=CLEAR
3
Press the * key or the # key until the
desired operation appears in the
display.
Transmission (SEND MODE)
Confidential transmission
Polling
Serial Polling
Broadcasting
Relay Request
1
T
TIMER
all-FO4700.book Page 102 Friday, November 4, 2005 9:17 AM
To Next Page
Loading...
