Programming Auto-Dial Numbers
46
Clearing auto-dial numbers
Note: You cannot clear a number if it is used in a program or timer oper-
ation, if it is used to specify the relay fax machine in a relay group, or if it
is included in a Group Key. First clear the number from the operation or
group, then perform the following clearing procedure. To check where
the number is used, print out the Program/Group List, the Timer List,
and/or the Relay Group List as explained in Chapter 7.
1
Press these keys:
The display will show:
2
Press 2 to select CLEAR.
3
To clear a Rapid Key, press the Rapid
Key.
To clear a Speed Dial number, press
the SPEED DIAL key and then enter
the number with the numeric keys. (If
you enter less than 3 digits, press the
START key to complete the entry.)
Example: Rapid Key 02
4
Press the START key.
FUNCTION
3
1
1:FAX/TEL. # MODE
1=SET, 2=CLEAR
B
02
2
START
all-FO4700.book Page 46 Friday, November 4, 2005 9:17 AM
To Next Page
Loading...
