E-12
Gently remove dust from the back panel, using a
vacuum cleaner attachment or similar tool.
Pre-fi lter
To maintain optimum performance of this air purifi er, please clean the unit including the fi lter
periodically.
Be sure to disconnect the power cord from the wall outlet before performing any maintenance.
CARE AND MAINTENANCE
Pre-fi lter
UNIT
CAUTION
Do not apply excessive pressure, when
scrubbing the pre-fi lter.
1. Add a small amount of kitchen detergent
to water and soak for about 10 minutes.
2. Rinse off the kitchen detergent with clean
water.
3. Completely dry the fi lter in a well-
ventilated area.
Wipe with a dry, soft cloth
For stubborn stains or dirt, use a soft cloth
dampened with warm water.
CAUTION
•
Do not use volatile fl uids
Benzine, paint thinner, polishing powder, etc. , may damage the surface.
•
Do not use detergents
Detergent ingredients may damage the unit.
SENSOR
1. Remove the Catch Panel.
2. Remove the Pre-fi lter.
3. Remove the Sensor fi lter.
4. If it is very dirty, wash it with water and dry
it thoroughly.
Dust sensor
fi lter
NOTE
How to clean hard to remove dirt
Pre-fi lter
OM_FP-FM40Y_ID-EN.indb Sec1:12OM_FP-FM40Y_ID-EN.indb Sec1:12 7/27/2558 BE 5:51 PM7/27/2558 BE 5:51 PM
To Next Page
Loading...
Need help?
General
