What to do if Sharp FP-J30TA discharged air has an odor?
If the discharged air from your Sharp Air Cleaner has an odor, check if the filters are heavily soiled and replace them if needed. Note that Plasmacluster Air Purifiers emit small traces of ozone, which may produce an odor. However, these ozone emissions are well below safety levels.
Why is Plasmacluster Ion Indicator not lighting on my Sharp FP-J30TA?
If the Plasmacluster Ion Indicator on your Sharp Air Cleaner doesn’t light up, check if the SLEEP mode is selected, as the indicator light turns off 3 seconds after SLEEP mode is activated. Also, verify if the Plasmacluster Ion is turned OFF. Press the button for 3 seconds to turn it On. Finally, check if the Light Control is OFF; press the button for 3 seconds to turn it On.
How to fix dust and smoke not removed by Sharp Air Cleaner?
If your Sharp Air Cleaner isn't removing dust and smoke effectively, clean or replace the filters if they appear heavily soiled.
Pre-filter traps dust and other large airborne particles.
HEPA filter traps 99.97% of particles as small as 0.3 microns.
Plasmacluster treats air by emitting a balance of positive and negative ions.
Important precautions to avoid hazards during unit operation.
Advice on placing the unit for optimal performance and safety.
Instructions for correct filter care and maintenance.
Standard air purification with selectable fan speeds.
Releases Plasmacluster ions and strong airflow for 60 minutes.
Adjusts fan speed between MED, MAX, and SLEEP modes.
Select the time for automatic unit shutdown.
Adjust Plasmacluster Ion Indicator light settings.
Control the Plasmacluster Ion generation feature.
General| Brand | Sharp |
|---|---|
| Model | FP-J30TA |
| Category | Air Cleaner |
| Language | English |
To Next Page
