– 45 –
HT-CN400DVH/HT-CN400DVE/HT-CN500DVH/HT-CN500DVE
In this unit, the terminal with asterisk mark (*) is (open) terminal which is not connected to the outside.
1 GND-SUB Substrate ground.
2, 3 OUT2B Output half bridge 2B.
4 VCC2B Positive supply.
5 GND2B Negative supply.
6 GND2A Negative supply.
7 VCC2A Positive supply.
8, 9 OUT2A Output half bridge 2A.
10, 11 OUT1B Output half bridge 1B.
12 VCC1B Positive supply.
13 GND1B Negative supply.
14 GND1A Negative supply.
15 VCC1A Positive supply.
16, 17 OUT1A Output half bridge 1A.
18* N.C. Not connected.
19 GND-clean Logical ground.
20 GND-Reg Ground to regulator VDD.
21, 22 VDD 5 V regulator reference to ground.
23 IBIAS High logical state setting voltage.
24 CONFIG Configuration pin.
25 PWRDN Stand-by pin.
26 TRI-STATE Hi-Z pin.
27 FAULT Fault pin advisor.
28 TH-WAR Thermal warning advisor.
29 IN1A Input of half bridge 1A.
30 IN1B Input of half bridge 1B.
31 IN2A Input of half bridge 2A.
32 IN2B Input of half bridge 2B.
33, 34 VSS 5 V regulator reference to + VCC.
35, 36 VCC Sign Signal positive supply.
Port NamePin No.
Function
IC500, IC501, IC502 92LRCI0505-001: Power Amp. (STA505)
To Next Page
Loading...
