Sharp HT-CN410DVH - Page 51

HT-CN410DVH
51
IC201, Programmable Multimedia and DSP Processor (ES6809PADF)
Table 1 ES6809 Pin Description (Continued):
Names Pin Numbers I/O Definitions
TSD2
124
O
Audio transmit serial data port 2.
AOUT_O3L O
Audio left channel 3 out.
TSD3
125
O
Audio transmit serial data port 3.
AOUT_O3R O
Audio right channel 3 out.
TBCK
126
O
Audio transmit bit clock.
AOUT_O1R O
Audio right channel 1 out.
TXD0
127
I/O
Serial port 0 transmit.
AOUT_O4L I/O
Audio left channel 4 out.
RXD0
128
I/O
Serial port 0 receive.
AOUT_O4R I/O
Audio right channel 4 out.
MCLK 129 I/O
Audio master clock for audio DAC.
TXD1 131 I/O
Serial port 1 transmit.
RXD1 132 I/O
Serial port 1 receive.
AUX3[5]
135
I/O
AUX3 data I/O 5.
CAMIN[5] I/O
Camera I/O 5.
AUX3[0]
136
I/O
AUX3 data I/O 0.
CAMIN[0] I/O
Camera I/O 0.
TX 137 I
Zero crossing of TE.
RX 139 I
Zero crossing of RF envelope.
LDCO 140 O
CD/DVD laser diode sekect.
LG 141 O
DVD-RAM land/groove flag for next track.
IP2 142 I
DVD-RAM header position index 2.
SDEN 143 O
RF chip serial data enable.
SDATA 144 I/O
Data signal to/from RF chip.
SCLK 145 O
Serial clock source to RF chip.
DFCT 146 I
Detect flag input signal.
MIRR 147 I
Mirror detect input.
LDON 148 O
Laser diode on/off control.
BSUM 149 I
Photodiode subbeam addition input signal.
FE 150 I
Focus input error signal.
CE 151 I
centre error input signal.
TE 152 I
Tracking error input.
RFENV 153 I
RF ripple envelope input signal.
VREFOUT 154 I
Reference voltage for servo analog output signals.
VREFIN 155 I
Reference voltage for servo analog input signals.
DMO 159 O
Spindle drive.
FOO 160 O
Focus drive.
SLO 161 O
Sled drive.
RPBC 162 O
RF envelope balance control.
TRO 163 O
Track drive.
NC 164 O
No connect.
TEBC 165 O
Tracking error balance control.
REFD 166 I
Flash reference decouple.
IN_M 167 I
Analog RF signal (minus).
IN 168 I
Analog RF signal (plus).