EN
but it will re-enter pairing mode
automatically.
1. While in ON mode, press the
(Bluetooth) button on the remote
control or on the unit to select
Bluetooth mode. The Blue indicator
will light ash.
2. Activate your Bluetooth device and
select the search mode. “HT-SB140”
will appear on your Bluetooth device
list.
If you cannot nd the unit, press and
hold the „
/ PAIR“ button on the
remote control to be searchable. After
the “Pairing” voice prompt and the Blue
indicator will ash rapidly.
3. Select “HT-SB140” in the pairing list.
After the “Paired” voice prompt, the
system is successfully connected and
the Blue indicator will light up solidly.
4. Begin playing music from the
connected Bluetooth device.
To disconnect the Bluetooth function,
you can:
Switch to another function on the unit.
Disable the Bluetooth function on
your device.The device is successfully
disconnected from the unit after the
“Disconnected” voice prompt.
Press and hold the “
/ PAIR” button on
the remote control.
TIPS:
• Enter „0000“ for the password if
necessary.
• If no other Bluetooth device pairs with
this player in 2 minutes, the player will
reconnect to the previous connection.
• The player will also be disconnected
when your device is moved beyond the
operational range.
• If you want to reconnect your device
to this player, place it within the opera-
tional range.
• If the device is moved beyond the
operational range, when it is brought
back, please check if the device is still
connected to the player.
• If the connection is lost, follow the
instructions above to pair your device
to the player again.
Listen to Music from Bluetooth
Device
If the connected Bluetooth device
supports Advanced Audio Distribution
Pro le (A2DP), you can listen to the
music stored on the device through the
soundbar‘.
If the device also supports Audio Video
Remote Control Pro le (AVRCP), you
can use the soundbar‘s remote control
to play music stored on the device.
1. Pair your device with the player.
2. Play music via your device (if it
supports A2DP).
3. Use supplied remote control to control
play (if it supports AVRCP).
To pause/resume play, press the
/
PAIR button on the remote control.
To skip to a track, press the
/
buttons on the remote control.
Troubleshooting
To keep the warranty valid, never try
to repair the system yourself. If you
encounter problems when using this unit,
review the following before requesting
service.
No power
Ensure that the AC cord is properly
connected.
Ensure that there is power at the AC
outlet.
Press standby button on the remote
control or soundbar to turn the soundbar
on.
No sound
Increase the volume. Press Volume Up on
the remote control or on the right side of
the soundbar.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
