LC-19D1E/S-BK/WH
3 – 35
2) Explanation of Hotel menu
Explanation
1 Public mode It is an item that sets whether to use the hotel mode function in the adjustment process.
Hotel mode means: The state (state of PUBLIC MODE=ON) after the hotel mode function is executed.
2 Power on fixed It is fixed to "Power on". (When "fixed" is selected).
Even if the remote control key or MAIN key is pushed, the power supply is not turned off.
This item is not displayed to make "HOTEL POWERFIX" of adjustment process mode 2 "Off". (defalt:ON)
3 Maximum volume Setting of the maximum audio level: can not be controlled volume beyond the set-up value.
4 Volume fixed Volume is fixed, and can not be changed.
The key which becomes invalid: "VOL+/-" key (both remote control and a main unit) / "MUTE"key.
5 Volume fixed level Determine the volume to fix with "Volume fixed".
6 RC button The key received by a remote control key can be restricted or forbidden.
a) When "limited" is selected, it accept only "power ", "volume ", "P "key and dimming (brightness sen-
sor).
b) When "No respond" is selected, none of keys are received (included MAIN power key).
7 Panel button Make Operation by a main unit key void excluding a MAIN power key.
• However, it is not concerned with a setup but, during hotel menu starting and a hotel menu, all the keys can be
used.
8 Menu button
When "No respond" is selected, a menu key by the remote control and a menu key on the main unit do not start a user
menu.
• However, it is not concerned with a setup but during hotel menu, all the keys can be used.
9 On screen display It does not carry out the OSD display of a menu system, a channel call, a volume bar, and call display of a direct key.
10 Blue screen It sets whether to make it to "Blue Screen" at no signal.
11 Input mode start When the power supply switches on, starting input source or channel can be set.
12 Input mode fixed Fix an input source which is set at Input mode start or a channel,
then not be able to choose the other input source" channel.
13 232C Power on When the standby mode, validity/invalidity in power supply ON by 232C command is set.
14 RC path through When connect to STB at a hotel, it is set whether to send the received remote control signal to the STB side by the set.
15 Reset Reset a hotel menu. In this case, the preset values in a hotel menu are initialized.
16 Enter Execution of a preset value
To Next Page
Loading...
Need help?
General