EasyManua.ls Logo

Sharp LC-19D1E/S-BK/WH

Sharp LC-19D1E/S-BK/WH
160 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
LC-19D1E/S-BK/WH
4 – 22
<When EXT5 is used for external input> No picture on the display (8)
No EXT5 (PC- terminal) output of the external input system.
Checklist:
1) Is “INPUT SOURCE” button on the remote control set up correctly? Set it as “EXT5” with the INPUT SOURCE button on the remote
control.
2) Connect the commercial PC-Cable to the PC terminal of an external device. See the operation manual.
3) Is PC-Connector disconnected or connected improperly? Connect it correctly as per the operation manual.
YES
Is “EXT5” selected with button on the remote control?
NO
Select “EXT5” with button on the remote control.
YES
Is ANALOG-RGB signal (PC_R/G/B) sent to pins (1), (2) and (3)
of EXT5-TERMINAL (SC401)?
NO Check PC-cable and external connection.
YES
Is ANALOG-RGB signal (PC_R/G/B) sent to pins (T1), (V1) and
(M1) of IC801 (DVP-M2)?
NO Check EXT5-TERMINAL and peripheral circuits.
YES
Is LVDS video signal (RA± - RD±) output from pins (P22)(P23) -
(V22)(V23) of IC801 (DVP-M2), and is RCLK signal (RCLK±)
output from pins (U22)(U23)?
NO Check pins (R19)(D5) of B3.3V line of IC801 (DVP-M2), pins
(D12) of B1.5V line, pins (B6)(A6) of SDA1/SCL1 line and
peripheral circuits.
YES
Is RSDS-R/G/B signal (R[0:2]±, G[0:2]±, B[0:2]±) output from
pins (53) -(72) of IC9201 (RSDS-TRANSMITTER) , and is CLK
signal (CK±) output to pins (60) and (59)?
NO Check pins (1) and (9) of B3.3V line of IC9201 (RSDS-TRANS-
MITTER), short circuits and peripheral circuits.
YES
Is RSDS-R/G/B signal (R[0:2]±, G[0:2]±, B[0:2]±) and CLK signal
(CK±) input to connector (SC9201) of LCD-PANEL?
(RSDS-R signal:22-27pin, RSDS-G signal:57-62pin, RSDS-B
signal:66-71pin, CK± signal:33/32pin)
NO Check whether there is short-circuit at CONNECTOR SC9201 of
LCD-PANEL and also check peripheral circuits.
YES
Is liquid crystal drive power supply input to CONNECTOR
SC9201 of LCD-PANEL?
(VLS_B14.6V=40/41/42pin, VGH_B32V=5/6pin,VGL_-6V=2/
3pin, COM-BIAS=75/76/77pin)
NO Please check REGULATOR-circuit of a defective voltage respec-
tively.
YES
Replace LCD-PANEL.

Table of Contents

Related product manuals