Appendix
Problem Possible Solution
• No power • Check if you pressed POWER on the remote control unit. (See page 16.) If the
indicator on the TV/DVD does not light up, press POWER on the TV/DVD.
• Is the AC cord disconnected? (See page 9.)
• Has the power been turned on? (See page 16.)
• Unit cannot be operated. • External influences such as lightning, static electricity, may cause improper
operation. In this case, operate the unit after first turning on the power of the
TV/DVD or unplugging the AC cord and replugging it in after 1 or 2 minutes.
• Remote control unit does not • Are batteries inserted with polarity (+, -) aligned? (See page 10.)
operate. • Are batteries worn out? (Replace with new batteries.)
• Are you using it under strong or fluorescent lighting?
• Is a fluorescent light illuminated near the remote control sensor?
• Picture is cut off screen. • Are screen mode adjustments such as view mode choose made correctly? (See
page 30.)
• Strange color, light color, or color • Adjust the picture tone. (See page 23.)
misalignment • Is the room too bright? The picture may look dark in a room that is too bright.
• Power is suddenly turned off. • Is the sleep timer set? (See page 20.)
• Check the power control settings. (See page 16.)
• The TV/DVD's internal temperature has increased.
Remove any objects blocking vent or clean.
• No picture • Is connection to other components correct? (See pages 26 to 27.)
• Is correct input signal source selected after connection? (See page 25.)
• Is the correct input selected? (See page 25.)
• Is picture adjustment correct? (See page 23.)
• No sound • Is the volume too low? (See page 19.)
• Is "OFF" selected in "SPEAKERS"? (See page 31 .)
The example of an error message Possible Solution
displayed on a screen
• DIGITAL CHANNEL SIGNAL • Check the antenna cable. Check that the antenna is correctly setup.
STRENGTH IS LOW
• DIGITAL CHANNEL IS • It is subscription channel. Contact the service provider.
SCRAMBLED
• AUDIO ONLY • The channel has audio contents only.
Cautions regarding use in high and low temperature environments
• When the TV/DVD is used in a low temperature space (e.g. room, office), the picture may leave trails or appear slightly
delayed. This is not a malfunction, and the TV/DVD will recover when the temperature returns to normal.
• Do not leave the TV/DVD in a hot or cold location. Also, do not leave the TV/DVD in a location exposed to direct sunlight
or near a heater, as this may cause the cabinet to deform and the Liquid Crystal panel to malfunction.
Storage temperature: -4°F to +140°F (- 20°C to +6O°C)
(_)= 56
To Next Page
Loading...
