LC-32AX3H/M/X
LC-37AX3H/M/X
13
<Step 5>
The rewriting program (IAP Writer) on the PC dictates writing. (Writing conditions are indicated on the IAP
Writer.)
<Step 6>
Wait until Step 5 is ended.
<Step 7>
When ended, exit the IAP Writer.
<Step 8>
Turn off the AC power of the unit. (Unplug the AC cord.)
<Step 9>
Remove the cable from the jig PWB and the AV PWB.
<Step 10>
Turn on the AC power of the unit to check for operation.
(If "TV/VIDEO" and "VOL (+)/(–)" are available, rewriting is completed.)
Factory initialization (INDUSTRY INIT) is required after version update.
3. Entering and exiting the adjustment process mode
(1) Before entering the adjustment process mode, press the "RESET" button or adjust the menu image to reset
the AV position.
(2) Unplug the AC power cord of the running TV to force off the power.
(3) While holding down "VOL (–)" and "TV/VIDEO" keys at once, plug in the AC power cord to turn on TV. The
letter K appears on the upper left of the screen.
(4) Next, hold down the "VOL (–)" and "CH (Ù)" keys at once. Multiple lines of blue characters appearing onscreen
indicate that the unit is now in the adjustment process mode. If you fail to enter this mode (the display is the
same as normal startup), retry the procedure.
(5) To exit the adjustment process mode after adjustment is completed, unplug the AC cord to force off the power.
(When the power is turned off with the remote control, once plug the AC cord and after approx. 10 seconds
plug it in again.)
Caution: Use due care in handling the information described here lest the users should know how
to enter the adjustment process mode. If the setting is tampered with in this mode,
unrecoverable system damage may result.
To Next Page
Loading...
