13
Preparation
Removing the stand
Before detaching (or attaching) stand, unplug the AC cord from the AC input and the system cable from the
Display.
CAUTION
• Do not remove the stand from the Display unless using an optional wall mount bracket to mount it.
Before attaching/detaching stand
• Before performing work make sure to turn off the System.
• Before performing work spread cushioning over the base area to lay the Display on. This will prevent it from
being damaged.
NOTE
• To attach the stand, perform the above steps in reverse order.
2
Detach the stand from the Display.
(Hold the stand so it will not drop from the edge of
the base area.)
1
Unfasten the four screws used to secure the
stand in place.
Setting the Display on the wall
CAUTION
• Installing the Liquid Crystal Television requires special skill that should only be performed by qualified service
personnel. Customers should not attempt to do the work themselves. SHARP bears no responsibility for improper
mounting or mounting that results in accident or injury.
Using an optional bracket to mount the Display
• You can ask a qualified service personnel about using an optional AN-37AG2 bracket to mount the Display
to the wall.
• Carefully read the instructions that come with the bracket before beginning work.
Vertical mounting Angular mounting
Hanging on the wall
AN-37AG2 wall mount bracket. 32/37 inch dual purpose
brackets. (See the bracket instructions for details.)
About setting the Display angle
LC-37G2X
•
You can set the Display on the wall
up to 5 degrees forward when the
speakers are attached and up to 20
degrees forward when the
speakers are not attached. Do not
set the angle outside those ranges.
LC-32G2X
•
You can set the Display on the wall
up to 15 degrees forward when the
speakers are attached and up to 20
degrees forward when the
speakers are not attached. Do not
set the angle outside those ranges.
CAUTION
• Do not remove the stand and speaker from the Display unless using an optional bracket to mount it.
LC-32/37G2X-a 04.5.22, 11:49 AM13
To Next Page
Loading...
Need help?
General