74
HOW TO SET THE FACTORY PRESETS
Turn off the Display by pressing MAIN POWER.
Press and hold down RESET on the AVC System and press MAIN POWER on the Display to turn on the
System.
All setting items (except TV channel) return to the factory presetting.
NOTE
• Running the factory presetting operation also clears the password.
You can run the Auto Installation again by using the following steps.
1 Turn on the power of the Display and the AVC System.
2 Press MENU. (Make sure the menu screen displays.)
3 Press c/d to select “Setup”.
4 Press a/b to select “Auto Installation”, and then press ENTER.
5 Press c/d to select “Yes”, and then press ENTER.
NOTE
• As a precautionary measure, make a note of your password above, scissor it from this manual, and keep it in a familiar
place.
The password is .
LC-32/37G2X-K 04.5.22, 0:03 PM74
To Next Page
Loading...
