58
LC-32LE240
LC-40LE240
SOFTWARE UPDATE
20. SOFTWARE UPDATE
In MB62 project there is only one software. From following steps software update
procedure can be seen:
1. MB62_en.bin, mboot.bin and usb_auto_update_T4.txt documents should copy directly
inside of a flash memory(not in a folder).
2. Put flash memory to the tv when tv is powered off.
3. Power on the and wait when the tv is opened.
4. If First Time Installition screen comes, it means software update procedure is
succesful.
19.7. USB Operations
USB operations option can not be used directly. It can be used for updating panel tool, hw
congiguration etc.
1. MB62 en. bin, mboot.bin and usb_auto_update_mb62.txt documents should copy directly
inside of ash memory ( not in a folder).
2. Put ash memory to the TV when TV is powered off.
3. Power on the TV by main switch and press OK in remote control continuously during 3 -4
seconds. Then led will start blinking (red / green) quickly.
4. If First Time installation screen comes, it means software update procedure is successful.
To Next Page
Loading...
Need help?
General