EZ SETUP
EZ
SETUP during the First Power
On
2
PLEASE
WAIT
AUTO
PROGRAMMING
~STEREO
SAP
MONO
Once EZ SETUP is completed, the lowest channel
number memorized will be displayed.
The tuner will automatically search for the
broadcasting or cable TV channels for ANALOG
based on your selection
in
step
2.
If you select
"AIR", the tuner will automatically search for the air
channels and if you select "CABLE ANALOG", the
tu
ner will automatically search for analog cable
channels. (The channel number will automatically
increase when it appears.)
Press ENTER to access START EZ SETUP mode.
Press
..
IT
to select "YES", and press ENTER.
INOTE >
• If you want to stop the EZ SETUP process once it has
started, press MENU and it will
be
canceled. If you want
to set up again, please see CH SETUP. (See page 23.)
..
INOTE >
Do not let the EZ SETUP screen remain unattended for a
long time.
If EZ SETUP does not memorize all the channels in your
region, please see CH SETUP for more information on
manually memorizing the channels using CH SETUP.
It may be difficult to preset when the broadcasting signals are
weak, the channel cycle frequency is incorrect or the fre-
quency jamming is occurring around the area. Please see CH
SETUP for more information on manually memorizing the
channels using CH SETUP.
INOTE >
• If you select "OFF", EZ SETUP will be canceled.
Press POWER, located on the upper side of the
main unit, to turn on the TV. The SELECT
LANGUAGE mode will be displayed.
Press
JIJJJ,JT
to select "ENGLISH", "ESPANOL"
(Spanish) or "FRANQAIS" (French).
POWER
[
/ggQQ~
V
• When you turn
on
the TV for the first time, it will
automatically memorize the broadcasting channels.
Please perform the following instructions before you
press POWER.
(1) Insert the batteries into the remote control. (See
page 7.)
(2)
Connect the antenna cable to the LCD TV set.
(See page 8.)
(3)
Plug
in
the
AC
cord to the wall outlet. (See page
9.)
14
@
To Next Page
Loading...
