Basic Operation
(POWER)
o
POWER
indicator
• Press POWER. The LCD TV set is turned on.
On-screen
display
I~s
T E R
EO
SAP
MONO
INOTE >
• The On-screen display disappears after a few seconds.
• To turn off the main power, press POWER again.
Turn
on
the power of the connected video
equipment.
Press INPUT to select the applicable input source.
The screen changes
in
order of INPUT1 ,INPUT2,
INPUT3 and TV mode each time INPUT is pressed.
INPUT1 mode
INPUT11
4IDP
INPUT2 mode
.INPUT21
.J.
INPUT3 mode
INPUT3]
.J.
TV
mode
To
turn
off
the
LCD TV
set
Press POWER. The POWER indicator will turn red.
To
turn
th~
LCD TV
set
back
on
Press POWER again. The POWER indicator will turn
green.
INOTE >
• To select the "STANDBY MODE" on the MENU
screen, the TV enters standby mode. (See page 30.)
INOTE >
INPUT1 : .
Used for video equipment connected to the COMPONENT
input terminals.
INPUT2 :
Used for video equipment connected to the INPUT2
terminal.
The S-video input terminal is additionally provided for
the INPUT2. If both the S-video terminal and normal
video terminals are connected with cables, the S-video
input terminal takes priority.
INPUT3 :
Used for video equipment connected to the INPUT3
terminals.
@ 15
To Next Page
Loading...
