Preparation
Before using the LCD
TV
set for the first time, install the two "AAA" size batteries (supplied) in the remote control.
When the batteries become depleted and the remote control fails to operate, replace the batteries with new "AAA"
size batteries.
1 Open the battery cover. 2 Insert two "AAA" size batteries.
3 Close the battery cover.
®
• Detach the cover
while pressing the
(y)
part.
• Place batteries with their
terminals corresponding
to the
(+) and
(-)
indications in the battery
compartment.
• Align the tab on the battery cover
(CD)
and place it while pressing the tab
(®)
to close it.
Precautions regarding batteries
Improper use
of
batteries can result in a leakage of chemicals and/or explosion. Be sure to follow the instructions
below.
Place batteries with their terminals corresponding to the (+) and
(-)
indications.
Different types
of
batteries have different characteristics. Do not mix batteries
of
different types.
Do not mix old and
new
batteries. Mixing old and
new
batteries can shorten the life
of
new
batteries and/or cause
old batteries to leak chemicals.
Remove batteries
as
soon as they are depleted. Chemicals that leak from batteries can cause a rash. If chemical
leakage is found, wipe it off with a cloth.
The batteries supplied with the LCD
TV
set
may
have a shorter operating time due to storage conditions.
If the remote control is not to be used for an extended period of time, remove the batteries from the remote control.
Use the remote control by pointing it towards the remote sensor
window
of
the main unit. Objects between the remote control and
sensor window
may
prevent proper operation.
Cautions regarding use of the remote control
• Do not apply shock
to
the remote control. In addition,
do
not
expose the remote control to liquids, and
do
not place it in an area
with high humidity.
Do not install
or
place the remote control
under
direct sunlight. The
heat
may
cause deformation
of
the unit.
• The remote control
may
not work properly if the remote sensor
window
is under direct sunlight
or
strong lighting. In such a case,
change the angle
of
the lighting
or
main unit,
or
operate the remote
control closer to the remote sensor window.
?
•
@7
To Next Page
Loading...
