Basic Operation (Continued)
Sounid Volume
• To adjust
the
volume
To
display
the
Receiving
Channel Information
VOLUME
50
11111111111111111111111111111111111111111111111111····
••••••
• Press VOL (+) to increase the sound volume.
The bar indicator shifts right.
TV·PG
DlSV
~STEREO
<ON
AIR
SAP
<ON
AIR
rIJNO
10
(While viewing analog
channel)
Press DISPLAY once. The display appears as
shown on below. If the viewing channel is a digital
channel, the information of channel number, audio
service type, broadcast station, program information
and V-Chip rating will appear.
MTS
MU~M
~
I@'
~~(~
~
SLEEP
0'0'
0
OWER
• •
<D®®
@)®(§)
CD®®
0®e
• Press VOL
(-)
to decrease the sound volume.
The bar indicator shifts left.
Press DISPLAY again to return to normal screen.
VOLUME
10 1111111111············································
••••••
• To mute
the
sound
• Press MUTE to temporarily turn off the sound.
The MUTE mark
D~
is displayed for 4 seconds.
I~
• Press MUTE or VOL
(+)/(-)
to turn the sound back to
the previous level.
The mute function is automatically turned off when
any of the following buttons is pressed: POWER,
MUTE, VOL(+)/(-) or MTS.
VOLUME
10 1111111111············································
••••••
INOTE >
• When VOL (+)/(-) is pressed
in
the Mute mode, the sound
turns on and the volume indicator is displayed.
• The Mute function is canceled when POWER is pressed.
• To select MTS (Multichannel TV Sound)
Press MTS to display the MTS screen.
Press MTS to select the MTS settings.
STEREO: stereo audio
SAP: secondary audio program
MONO: monophonic audio
I
~STEREO
<ON
AIR
SAP
<ON
AIR
fl)NO
INOTE >
• "ON AIR" appears when a STEREO or SAP broadcast is
being aired.
• "MTS" function is only available when receiving TV Analog
signal.
16
@
To Next Page
Loading...
