Basic
Operation (Continued)
Changing Channels
Selecting
Menu·····
Items
Your new Television is capable of receiving the full range
of AIR-TV channels available today, from the most
advanced digital channels, to the more traditional analog
channels. As the transition toward full digital TV
continues, some AIR-TV systems in the USA will have a
mixture of analog and digital channels
in
their lineups.
OWER
•
•••
•••
•••
•••
MTS
MUT~PUT
O'''Q
~e&
~~~
$ S
SLEEP
o '0' 0
The menus can
be
used to adjust the various settings of
your LCD TV set. Select the desired menu item by
following the steps below.
INOTE >
• The items displayed differ depending on the setting
conditions.
• The. item selected is displayed
in
yellow.
• Settings most recently adjusted will be saved
in
memory.
• Using
the
remote
control
Control panel of the main unit
• Using
the
control
panel
of
the
main
unit
C:::lc:::::l
000
.••.
\~
,...
VOl
+.
V
CH·X
MENU·
·INPUf
•..
POWEA.·
. _
!
Press MENU RETURN to return to the previous
screen, or press MENU to exit.
Press
<lllIII.
to select the desired menu item.
• The cursor moves left or right.
• The cursor indicates the selected menu item.
Press MENU on the remote control to display the
Menu screen.
Press
£'/'Y
to select the desired item, and press
<lllIII.
to adjust the selected item.
• For "AV MODE", "ADVANCED" and "RESET",
press ENTER to display the setting screen.
Press FLASHBACK to switch to the previously
tuned channel.
Press FLASHBACK again to switch back to the
currently tuned channel.
INOTE >
• FLASHBACK will not work if no channel has been
changed after TV is turned on.
You can change channels
in
several ways.
• Method 3
Using the control buttons 0-9, e(DOT) and ENT to
select channels for VHF/UHF/CATV/DIGITAL.
To
select
1
or
2-digit
channel
number
(e.g., Chan-
nel 5
or
Channel 15):
Press 5 button, and then press ENT button, or:
Press 1 button, and 5 button, and then press ENT
button.
• Method 2
• Method 1
You can select channels using
CH
(A)/(V)
on the
remote control or on the upper side of the main unit.
INOTE >
• When selecting 1-digit channel number, it is not necessary to
press 0 before the number.
To
select
a
digital
channel
number
(e. g. Channel
10.1):
Press 1 button
--+
0 button
--+
e(DOT) button
--+
1
button
--+
ENT button.
INOTE >
• Complete the above steps within a few seconds.
• When you enter 0-9 and e(DOT), channel selection will be
made if there is no operation for a few seconds.
Press MENU on the main unit to display the Menu
screen.
Press VOL
(-)/(+)
to select the desired menu item
..
• The cursor moves left or right.
• The cursor indicates the selected menu item.
Press
CH
(V)/(A)
to select the desired item, and
press VOL
(-)/(+)
to adjust the selected item.
• For "AV MODE", "ADVANCED" and "RESET",
press INPUT to display the setting screen.
Press MENU to exit.
@
17
To Next Page
Loading...
