IMPORTANT SAFETY INSTRUCTIONS (Continued)
• If
an
outside antenna is connected to the television equipment,
be
sure the antenna system is grounded so as to
provide some protection against voltage surges and built-up static charges. Section
810
of the National Electrical
Code provides information with respect to proper grounding
of
the mast and supporting structure, grounding
of
the lead-in wire to
an
antenna discharge unit, size of grounding conductors, location of antenna-discharge unit,
connection to grounding electrodes, and requirements for the grounding electrode.
EXAMPLE OF ANTENNA GROUNDING AS PER
NATIONAL ELECTRICAL CODE
ANTENNA
LEAD-IN
WIRE
ANTENNA
DISCHARGE UNIT
(NEC SECTION 810-20)
GROUNDING CONDUCTORS
(NEC SECTION 810-21)
GROUND CLAMPS
,:,'-
POWER SERVICE GROUNDING
ELECTRODE SYSTEM
NEC-NATIONAL
ELECTRICAL CODE (NEC ART 250, PART H)
• Lightning - For added protection for this television equipment during a lightning
storm, or when it is left unattended and unused for a long period
of
time, unplug
it from the wall outlet and disconnect the antenna. This will prevent damage to
the equipment due to lightning and power-line surges.
• Power Lines - An outside antenna system should not
be
located
in
the vicinity
of
overhead power lines or other electric light or power circuits, or where it can
fall into such power lines or circuits. When installing
an
outside antenna system,
extreme care should be taken to keep from touching such power lines or circuits
as contact with them might be fatal.
•
To
prevent fire, never place any type
of
candle or flames
on
the top or near the
TV set.
•
To
prevent fire or shock hazard, do not expose this product to dripping or
splashing. No objects filled with liquids, such as vases, should be placed on the
product.
•
To
prevent fire or shock hazard, do not place the
AC
cord under the
TV
set or
other heavy items.
• Do not display a still picture for a long time, as this could cause
an
afterimage to remain;
Install the product
on
the place where the
AC
cord can be unplugged easily from the AC outlet, or from the AC
INPUT terminal
on
the rear
of
the product.
To Next Page
Loading...
