Sharp LMV Series User Manual

25
8. Trouble Shooting:
1. Removing Motor (Fig. 25):
a. While running motor reduce speed to 60 RPM. This will lower
the stationary motor vari-disc to its lowest position.
b. Temporarily disconnect the power source.
c. Remove motor pulley cover “B” under the motor shaft, remove
grease fitting. Use 2 of the screws to insert into the pulley
spring washer/ plate “D”, taking care to tighten evenly.
d. Connect the power and increase the RPM to 3,000, which will
raise the motor vari-disc to gain access to the snap ring “G”.
e. Disconnect the power.
f. Remove snap ring “G”.
g. Remove the two motor mounting bolts “H”. You can now
remove the motor. (The lower pulley and spring assembly will
slide out and remain in the housing.)
h. Reverse above procedure to re-assemble.

Sharp LMV Series Specifications

General

Brand	Sharp
Model	LMV Series
Category	Lathe
Language	English