10. Maintenance
“Maintenance is more important than repair, and repair is better than purchase.”
The life of a machine can be greatly reduced if it has been properly maintained
and operated. The result will be premature wear, inability to hold tolerance
and poor finish on the workpiece. It is essential that operator be familiar with
the operation and maintenance of the machine.
Daily Maintenance:
1. Check oil level in the pump (Manual).
2. Lubricate machine per lubrication charts on page 7 & 8.
3. Run machine at 1,200 RPM for 2 to 3 min. prior to operation. This is
to allow the belt to stabilize.
4. At the close of each day:
a.
Workpiece should be removed, (if practical) and work table
should be cleaned and oiled.
b.
All machine locks should be loosened and sliding parts
lubricated. If practical, remove cutter.
c.
Headstock should be returned to its normal position if it has
been operated in a tilted position.
Monthly Maintenance:
a.
Check all clamping rails and sliding surfaces for wear.
b.
Check leadscrew backlash (Adjust if needed).
c.
Check quill lock and other moving parts for proper operation.
Quarterly Maintenance:
a. Check brake and belt.
b. Check if table is square with the head.
c. Do a general test on machine, check for worn parts and replace
as needed.
To Next Page
Loading...
Need help?
General
