11. Notice:
1. Machine Operation:
a.
Machine must be installed on a solid base.
b.
Be sure the machine base and surface have proper contact
before tightening anchor bolts.
c.
Be sure motor voltage conforms to the source voltage and
properly grounded.
d.
Turn off machine before changing gears.
e.
Be sure cutter or tool is clear of the workpiece before starting
or stopping the machine.
2. Machine Operator:
a.
Only authorized personnel should operate mill.
b.
If a problem is suspected, stop mill immediately, check for the
problem, and make any repair or adjustment that maybe
required.
c.
Auto feed lever must be in neutral before starting mill.
d.
Stop machine when inspecting tool or workpiece.
e.
Be certain that workpiece is properly clamped prior machining.
f.
Spindle must be kept clean and lubricated at all times.
g.
Keep tools and other objects off of table to eliminate damage or
nicks.
h.
Make sure spindle is up to speed before starting the machining
operation.
i.
Use a brush to remove chips.
To Next Page
Loading...
Need help?
General
