7.
Unpacking, moving, and floor space:
a. Methods of moving machine:
1.
Prior to unpacking or removing from skid, the machine should be
moved by the use of a forklift or reinforced cable (Fig. 20 & 21).
2.
Removal from the skid and any further movement of the machine
should be done by the use of a reinforced cable or by the eye bolt
located in the top of the ram.
Remarks:
1.
When lifting or moving machine, be sure area is clear of all personnel.
2.
Lifting machine by the use of eye bolt should be only when absolutely
necessary.
3.
When lifting or moving the machine before unpacking or removing
from the skid, observe any precautions or instruction that may be
printed on the crate.
4.
The machine can be balanced while being moved by changing the
location of table and or saddle.
5.
Do not attempt to raise the machine too high. The recommended height
is approximately 10 cm from the ground.
6.
If the machine is not stable when being lifted, adjust the rigging as
needed.
7.
Only use qualified forklift operators to move the machine.
To Next Page
Loading...
Need help?
General
