2.
Replacing the Speed Change Belt
a.
Refer to steps a. to g. on page 24 for removing motor.
b.
Remove drawbar.
c.
Remove bolts “J” from bearing housing “K”. Use 2 of the bolts
to push housing off of the housing “T”.
d.
Remove the 2 bolts “L” and sleeves “M” that hold the speed
change plate.
e.
Remove “N”, “O”, and “P” (Total of 6 bolts).
f.
Remove the 2 lower bolts “S” on the speed change housing
“Q”.
g.
Separate the upper housing “T” because the housings are
pinned together, it may be necessary to use a soft mallet to
separate them.
h.
After replacing the belt, reverse the above order to re-assemble.
To Next Page
Loading...
