3.
Brake Block Replacement (Fig. 27):
a.
Refer to steps a. to g. on page 24 and steps b. to g. on page 26.
b.
Remove the four bolts “V” (Fig. 28) so housing “T1” can be
removed. It may be necessary to use a soft mallet. (Housing
“T1” and “R” are pinned together).
c.
Remove vari-disk assembly set “E1” (Fig. 27) by removing bolt
“X”. Brake block “Y” can now be replaced.
d.
Reverse above order to re-assemble.
To Next Page
Loading...
