Sharp MX-2310U

6
Do not install the machine on an unstable or slanted surface. Install the machine on a surface
that can withstand the weight of the machine.
Risk of injury due to the machine falling or toppling.
If peripheral devices are to be installed, do not install on an uneven oor, slanted surface, or otherwise
unstable surface. Danger of slippage, falling, and toppling. Install the product on a at, stable surface
that can withstand the weight of the product.
Do not install in a location with moisture or dust.
Risk of re and electrical shock.
If dust enters the machine, dirty output and machine failure may result.
Locations that are excessively hot, cold, humid, or dry
(near heaters, humidiers, air conditioners, etc.)
The paper will become damp and condensation may form
inside the machine, causing misfeeds and dirty output.
SPECIFICATIONS (page 15)
If the location has an ultrasonic humidier, use pure water for
humidiers in the humidier. If tap water is used, minerals and
other impurities will be emitted, causing impurities to collect
on the inside of the machine and create dirty output.
When the machine is installed, the adjusters (5) must be lowered to the
oor to secure the machine (prevent it from moving).
Rotate the adjusters in the locking direction until they are in rm contact
with the oor.
If you nd it necessary to reposition the machine due to
rearrangement of your ofce layout or other reason, retract the
adjusters from the oor, turn off the power, and then move the
machine.
(After moving the machine, lower the adjusters again to secure the
machine.)
Locations exposed to direct sunlight
Plastic parts may become deformed and dirty output may result.
Lock Release
Installation notes
CAUTION
Locations with ammonia gas
Installing the machine next to a diazo copy machine may cause
dirty output.
Do not install the machine in a location with poor air
circulation.
A small amount of ozone is created inside the machine during
printing. The amount of ozone created is not sucient to be
harmful; however, an unpleasant odor may be noticed during large
copy runs, and thus the machine should be installed in a room with
a ventilation fan or windows that provide sucient air circulation.
(The odor may occasionally cause headaches.)
* Install the machine so that people are not directly exposed to
exhaust from the machine. If installed near a window, ensure that
the machine is not exposed to direct sunlight.
Near a wall
Be sure to allow the required space around the machine for
servicing and proper ventilation. (The machine should be no closer
than the distances indicated below from walls. The indicated
distances are for the case when a saddle nisher and large
capacity paper tray are not installed.)
30 cm
30 cm
45 cm
Locations subject to vibration.
Vibration may cause failure.
CAUTION
The machine includes a built-in hard drive. Do not subject the machine to shock or vibration. In
particular, never move the machine while the power is on.
• The machine should be installed near an accessible power outlet for easy connection.
• Connect the machine to a power outlet which is not used for other electric appliances. If a lighting
xture is connected to the same outlet, the light may icker.