16
SELECTING A SPECIAL MODE FOR FAX
The procedure for selecting a special mode for fax is explained below. The settings that can be selected vary for
each special mode, however, the general procedure is the same. The procedure for selecting "Erasing peripheral
shadows (Erase)" is explained below as an example.
1
Place the original.
When using the document glass, place the original
with the side to be scanned face down.
2
Select the desired special mode
(example: erase) settings in the touch
panel.
(1) Touch the [Special Modes] key.
(2) Touch the [Erase] key.
The erase settings will be configured to erase a
width of 3/4" around the edges of the original.
(3) Set the erase width to 3/4" using the
keys.
The erase area is set to "Edge Erase" by
default.
To select "Center Erase" or "Edge+Center
Erase", touch the appropriate key.
(4) Touch the [OK] key.
3
Select the destination and press the
[BLACK & WHITE START] key.
The side to be scanned must be face up!
OK
Dual Page
Scan
Card Shot
2in1
Erase
Timer
Program
Fax
Special Modes
1/3
Quick File
File
Special Modes
Sub Address
Address Book
Resend
Speaker
Send
Auto
Ready to send.
Fax
Image
Settings
Memory TX
Direct TX
Auto Reception
Fax Memory:100%
Scan
Special Modes
OK
OK
Cancel
3/4
(0~1)
inch
Edge
Edge+Center
Erase
Center
Erase
Edge
Erase
Erase
Mode Switch
8 x11
1
/
2
(1)
(2)
(3)
(4)
Cancel scanning
To Next Page
Loading...
