Sharp MX-3070N

COLOUR BALANCE ADJUSTMENT
SHARP
14
Automatic Colour Calibration – FACTORY MODE:
Note:
When adjusting colour balance before or after routine maintenance, always use the recommended paper
(Mondi 90gsm or equivalent) for optimum image quality.
DEFAULT COLOUR BALANCE SETTING:
Sim 63-11 For ENGINE:
Sim 67-26 For PRINTER:
Def 1 Standard Colour Balance setting (Default).
Def 2 Colour balance with slightly strong cyan.
Def 3 Colour balance with the emphasis on Cyan
COLOUR BALANCE ADJUSTMENT:
Sim 46-74 Half tone colour balance adjustment for COPY & PRINTER – select FACTORY.
PRINTER DENSITY CHECK:
Sim 64-05 Printer Self-Print Test (PCL)
Sim 64-06 Printer Self-Print Test (PS)
Manual Colour Calibration – SERVICE MODE:
HIGH DENSITY PROCESS CONTROL:
Sim 44-06 Execute High Density Process Control
COLOUR BALANCE ADJUSTMENT:
Sim 46-74 Half Tone Colour Balance Adjustment for COPY & PRINTER – select SERVICE.
MANUAL COLOUR BALANCE ADJUSTMENT:
Sim 46-21 Engine
Sim 64-06 Printer Self-Print Test (PS)
PRINTER DENSITY CHECK:
Sim 64-05 Printer Self-Print Test (PCL)
Sim 64-06 Printer Self-Print Test (PS)
SERVICE COLOUR TARGET SETTING:
Sim 64-05 Printer Self-Print Test (PCL)
Sim 64-06 Printer Self-Print Test (PS)
Return to Default Setting – SERVICE MODE:
STANDARD SERVICE TARGET SETTING:
Sim 63-08 Reset Standard Service Target for COPY.
Sim 67-28 Reset Standard Service Target for PRINTER.
COLOUR BALANCE ADJUSTMENT:
Sim 46-74 Half Tone Colour Balance Adjustment for COPY & PRINTER – select SERVICE.