Sharp MX-3070N

SHARP
IMAGE SEND COMMUNICATION ERROR
63
COMMUNICATION REPORT MAIN CODE [EXCLUDING FAX, PC-FAX & I-FAX]:
The communication report code is composed of the following: Communication Report: XX (XXXX);
The Upper 2 digits of the Communication Report Code:- Communication report code of 00 - 99
(Refer to communication report main code).
The Lower 4 digits of the Communication Report Code:- Refer to communication report sub code 1.
The Upper 2 digits:- Communication report sub code 1 (Refer to Communication report sub code 1).
The Lower 2 digits:- Communication report sub code 2 (Refer to Communication report sub code 2).
Notes:
1. The communication report sub code 1 and sub code 2 are in hexadecimal notation. (The others are in
decimal notation.)
2. The communication report sub code 1 is not used in these models.
Report Code
(Result)
Result Displayed
Communication Interruption Content
80
NG80 XXXX
*1
NIC connect failure (network abnormality)
 Check for disconnection of cables.
 A network trouble (CE-XX) occurs.
 The port is set to DISABLE.
 Authentication of the POP server is failed when POP before SMTP is
enabled.
 When an error other than the communication result code 93 or 94 in D-
SMTP send (including error response of 5XX)
83
NG LIMIT
In E-mail/FTP, Internet FAX send, the send data size exceeds the upper limit
of send data.
84
REJECTED
In e-mail receive, a sender is registered in receive reject address/domain.
<Receive>
85
NG85 XXXX
*1
In e-mail receive, an error occurs in communication with POP3 server.
 Header acquisition error.
 Time-out during mail receive
86
RECEIVED
In e-mail receive, an unsupported attached file is received. Only the TIFF-F
type is supported for attached files.
 The TIFF-F type of the attached file cannot be recognized.
 There is no attached file.
87
NG87 XXXX
*1
In e-mail receive, an attached file cannot be stored in memory.
* Memory over
88
NG88 XXXX
*1
In SMTP e-mail receive, an attached file cannot be stored in memory.
 Cannot be stored in memory.
 The number of items of acting receive data is the maximum, and an
additional data cannot be stored.
89
NG89 XXXX
*1
In SMTP e-mail receive, an error occurs in communication with the mail
server.
 Time-out occurs during e-mail receive.
90
NG90 XXXX
*1
After reservation by re-operation of document filing, conversion for image
send cannot be made.
91
NG91 XXXX
*1 *2
Data cannot be written to the memory device when Scan To USB is executed.
 The memory device is disconnected during writing to the memory device.
 An error occurs due to a memory device trouble.
92
NG92 XXXX
*1 *2
The USB device memory overflows during writing data into the memory
device when "Scan to USB" is executed.