Sharp MX-4100N - Page 218

MX-5001N SIMULATION 6 – 71
44-28
Purpose
Adjustment/Setup
Function (Purpose)
Used to set the process control execution
conditions.
Section
Process
Operation/Procedure
1) Select a target item of setting with [↑] [↓] key on the touch
panel.
2) Enter the set value with 10-key.
3) Press [OK] key. (The set value is saved.)
NOTE: Set the items to the default values unless a change is spe-
cially required.
ǂǂǂ6,08/$7,21ǂǂ12
&/26(
7(67
+$/)721(352&21$'-8670(17'$7$&/($5


$5(<28685("
<(6 12 (;(&87(
Mode Item/Display Content Setting range
Default
value
Process control
Enable/Disable
setting
A INITIAL YES When warm-up after clearing the
counter of the OPC drum and the
developer unit
Enable 0 - 1 0 0
NO Disable 1
B SW ON When supplying the power (when
clearing shut-off.)
Color process
control Enable
0 - 3 0 3
Process control
Disable
1
BK process control
Enable
2
Pixel count
judgment
(Judgement is
based on the setting
value of item K, L.)
3
C TIME After passing the specified time from
leaving READY continuously (Time
can be changed by INTERVAL TIME)
Color process
control Enable
0 - 3 0 3
Process control
Disable
1
BK process control
Enable
2
Pixel count
judgment
(Judgement is
based on the setting
value of item K, L.)
3
D HUM_LIMIT HUM judgment is made when turning
ON the power and after passing
TIME.
Color process
control Enable
0 - 2 0 0
Process control
Disable
1
BK process control
Enable
2
E HUM The temperature and humidity in side
the machine are monitored only
during a job for every 2hours (set by
item N). When the changes in the
temperature and the humidity are
greater than the specified level (the
set value of item O) in comparison
with the previous process control.
Color process
control Enable
0 - 2 0 0
Process control
Disable
1
BK process control
Enable
2