When this function is enabled, printing in printer
mode will automatically continue using a different
size of paper if the specified size of paper runs out
in all trays. This feature does not function in copy
mode.
1: FULL-SPEED
2: HI-SPEED
This sets the USB 2.0 data transfer speed. To obtain
the fastest speed when using the USB 2.0
connector, first verify that your computer meets the
system requirements (operating system and driver),
and then use this program to change the USB 2.0
mode to "Hi-Speed". Note that the setting should
not be changed while running a TWAIN driver. (For
the system requirements.)
If the paper runs out during printing and there is
paper of the same size in another tray, this function
automatically switches to that tray (excluding the
bypass tray). The function can be disabled.
MX-NB11 NETWORK EXPANSION
This is to select whether or not to make the network
connection by TCP/IP protocol effective
This is to select whether or not to apply to DHCP
network connection.
1: IP ADDRESS
2: SUBNET
3: GATEWAY
This is to set IP address, Subnet mask and Default
Gateway from the machine. This can also be used to
check the machine’s IP ADDRESS when "IP
ADDRESS" is selected. When the program number 4
"ENABLE DHCP" is "ON" and the machine is under
DHCP environment, the IP address on the display is
shown with " " at the tail end.
Note(s):-
*1: The scanning speed increases when the USB 2.0 mode is set to "HI-SPEED", however, the printing
speed does not increase considerably.
*2: When the 250-sheet paper feed unit is installed.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
