CONVENIENT COPY FUNCTIONS
25
Using the RSPF
1
Place the original(s) in the RSPF. (p.18)
If you place an odd number of originals for one-sided to two-sided copying,
the last page will be one-sided.
2
Press the [2-SIDED COPY ( )] key*
1
and
select the two-sided copy mode that you
wish to use.
The mode changes as follows each time you press
the [2-SIDED COPY ( )] key*
1
: "1 TO 1", "1 TO
2", "2 TO 2", "2 TO 1"
• "1 TO 2"*
2
: Two-sided copies from one-sided originals
• "2 TO 2":*
2
Two-sided copies from two-sided originals
• "2 TO 1": One-sided copies from two-sided originals
* When the RSPF is installed.
*
1
On the MX-B201, press the [2-SIDED SCAN] key.
*
2
MX-B201D only.
3
Press the [OK] key.
If you selected "1 TO 2" in step 2, select "LONG EDGE" or "SHORT EDGE"
and press the [OK] key. LONG EDGE and SHORT EDGE are shown in the
illustration on page 23.
4
If you selected "2 TO 1" or "2 TO 2", press
the [ ] key ( ) or [ ] key ( ) to select
the original size and then press the [OK]
key.
The following original sizes can be selected:
"A4", "B5", "A5", "8.5 x 14", "8.5 x 13", "8.5 x 11",
"8.5 x 5.5".
5
Select the number of copies and any other settings, and then
press the [START] key ( ).
The copy will be delivered to the paper output tray.
To cancel automatic two-sided copying, press the [CLEAR ALL] key
( ) or press the [2-SIDED COPY ( )] key, select the "1 TO 1",
and then press the [OK] key.
To Next Page
Loading...
