Sharp MX-B455W

2-46
COPIER►BASIC PROCEDURE FOR MAKING COPIES
Copy by automatically calculating the repeat count (Auto Repeat)
1
Place the original.
Place the original in the document feeder tray of the automatic document feeder, or on the document glass.
► AUTOMATIC DOCUMENT FEEDER (page 1-75)
► DOCUMENT GLASS (page 1-77)
2
Tap the [Detail] key to change to normal mode.
► Changing mode from each mode (page 2-5)
3
Tap the [Others] key, and then tap the [Repeat Layout] key.
4
Tap the [Auto Repeat] key.
5
Check the repeat faces which have
been calculated automatically.
Change the original size, paper size, or copy ratio by tapping
the respective [Original], [Paper Select], or [Copy Ratio] key
when necessary.
► SELECTING THE ORIENTATION AND SIZE OF THE
ORIGINAL (page 2-29)
► MANUAL RATIO SELECTION (page 2-23)
► SELECTING THE PAPER TRAY FOR COPYING (page
2-12)
Set so that there are one or more repeat faces.
6
Specify the repeat partition line.
After the settings are completed, tap and [Back] keys in
sequence.
• To cancel the Auto Repeat setting:
Tap the [Off] key.
• To cancel all settings:
Tap the [CA] key.
8½x11
8½x11
8½x11
Preview
Back
Start
Repeat Layout
Auto Layout of Repeat Face Based on Original, Paper Size and Ratio.
Others
Off
Fixed Repeat
Photo Repeat
Auto Repeat
Exposure
Select Type/Exposure
Background Adjustment
Change Size/Direction.
Original
Paper Select
Original
Current Setting
8½x11
8½x11
100%
Off
Parting Line
Copy Ratio
CA
Repeat
Number
1
Preview
Back
Start
Repeat Layout
Others
Off
Fixed Repeat
Photo Repeat
Auto Repeat
Exposure
Select Type/Exposure
Background Adjustment
Change Size/Direction.
Original
Paper Select
Copy Ratio
Original
Current Setting
Parting Line
100%
Off
CA
Auto Layout of Repeat Face Based on Original, Paper Size and Ratio.
8½x11
8½x11
Repeat
Number
1
8½x11
8½x11