1-64
BEFORE USING THE MACHINEâ–ºLOADING PAPER
Types of paper that can be set in each tray
*1 when a 600-sheet paper feed unit is installed
*2 when two 600-sheet paper feed units are installed
*3 when three 600-sheet paper feed units are installed
*4 "Plain Paper 1" is plain paper 16 to 24 lbs. bond (60 to 89 g/m
2
), "Plain Paper 2" is plain paper 24 to 28 lbs. bond
(90 to 105 g/m
2
).
*5 "Heavy Paper 1" is heavy paper up to 65 lbs. cover (176 g/m
2
), "Heavy Paper 2" is heavy paper up to 80 lbs. cover
(220 g/m
2
).
• For detailed information on the sizes and types of paper that can be loaded into each tray of the machine, see
"SPECIFICATIONS" in the "Start Guide" and "Paper Tray Settings (page 7-118)
".
• Recycled paper, colored paper and pre-punched paper must meet the same specifications as plain paper.
Before using any paper, consult the dealer or nearest SHARP Service Department.
Tray 1 Tray 2
*1
Tray 3
*2
Tray 4
*3
Bypass tray
Plain Paper 1
*
4
Permitted Permitted Permitted
Plain Paper 2
*
4
Permitted Permitted Permitted
Heavy Paper 1*
5
- Permitted Permitted
Heavy Paper 2*
5
- Permitted Permitted
Thin Paper - Permitted Permitted
Pre-Printed Permitted Permitted Permitted
Recycle Paper Permitted Permitted Permitted
Letter Head Permitted Permitted Permitted
Pre-Punched Permitted Permitted Permitted
Color Permitted Permitted Permitted
Labels - - Permitted
Glossy Paper - - Permitted
Transparency - - Permitted
Envelope - - Permitted
To Next Page
Loading...
Need help?
General
