Sharp MX-C300F - Page 154

MX-C250 SIMULATION 6 – 77
65 1 - 3 FAX initial setting Image quality priority selection Ordinary lettering 0 0 0
Small lettering 0 0 1
Fine 0 1 0
Very fine 0 1 1
Not used 1 0 0
Small lettering, medium tone 1 0 1
Fine, medium tone 1 1 0
Very fine, medium tone 1 1 1
4 - 8 FAX initial setting Density default setting OFF Automatic
Light 1 0 0 0 0
Slightly light 0 1 0 0 0
Middle 0 0 1 0 0
Deep 0 0 0 1 0
Slightly deep 0 0 0 0 1
Use default values Other settings than above
settings
66 1 FAX transmission
setting
Memory send/Direct send Default
setting
0 : Memory send 1 : Direct send
2 FAX transmission
setting
Quick Memory transmission
changeover
0 : Prohibited 1 : Permitted
3 FAX initial setting Designation of date and source
printing position
0 : Outside of document (out-
side of send data)
1 : Inside of document
(inside of send data)
4 - 5 FAX initial setting Address confirmation function OFF 0 0
ON 0 1
Only for applying the direct
input
1 0
Not used 1 1
6 - 8 Not used
67 1 - 4 FAX initial setting Interval between recalls when
busy
Setting range
1 - 15 min
4 - 15 min (Taiwan)
Two states input
5 - 8 FAX initial setting Number of re-calls when busy Setting range
0 - 15times (Japan, Taiwan)
0 - 14 times (North America,
Canada)
0 - 10 times (England, Ger-
many, France, Middle east,
South Africa)
0 - 9 (Australia, New Zealand,
Singapore, Malaysia, India)
0 - 3 (China, Hong Kong)
Two states input
68 1 - 4 FAX initial setting Interval between recalls when
communication error
Setting range
1 - 15 min
4 - 15 min (Taiwan)
1 - 15 min (Malaysia, Thailand,
India)
0 - 15 min (Other countries
than above countries)
0 : Re-send right after the line
is disconnected
Two states input
5 - 8 FAX initial setting Number of re-calls when communi-
cation error
Setting range
0 - 15times (Japan, Taiwan)
0 - 1 times (North America,
Canada, Australia)
0 - 5 times (England, Ger-
many, France, Middle east,
South Africa)
0 - 9 (Australia, New Zealand,
Hong Kong, Malaysia, India)
0 - 3 (China, Hong Kong)
0 - 14 (Taiwan)
0 - 9 (Singapore, Malaysia,
India, Brasil)
Two states input
69 1 - 4 Timer Setting of call time (T0 timer set-
ting) in automatic transmission
Setting range
30 - 45 s (China, Hong Kong)
30 - 75s (Japan)
30 - 35s (Russia)
30 - 60s (Other countries than
above countries)
5s intervals
X (ms) = (N*5) + 30
Two states input
5 FAX initial setting Selection of date and transmis-
sion source print
0 : OFF 1 : ON Two states input
6 - 8 Not used
SW
No.
Bit
No.
System set-
tings
Item SW selection and function Remarks