Sharp MX-C300F - Page 97

MX-C250 SIMULATION 6 – 20
26-30
Purpose
Setting
Function (Purpose)
Used to set the operation mode corre-
sponding to the CE mark (Europe safety
standards). (For slow start to drive the fus-
ing heater lamp)
Section
Operation/Procedure
1) Enter the set value with 10 keys.
2) Press [OK] /[START] key.
The set value in step 1) is saved.
* Even in Enable state, the control may not be executed due to
the power frequency, etc.
26-35
Purpose
Setting
Function (Purpose)
Used to set the display mode of SIM 22-4
trouble history when a same trouble
occurred repeatedly. There are two display
modes: display as one trouble and display
as several series of troubles.
Section
Operation/Procedure
1) Enter the set value with 10 keys.
1) Press [OK]/[START] key.
The selected set content is saved.
26-38
Purpose
Setting
Function (Purpose)
Used to set Continue/Stop of print when the
maintenance life is reached.
Section
Operation/Procedure
1) Enter the set value with 10 keys.
2) Press [OK]/[START] key.
The selected set content is saved.
26-53
Purpose
Setting
Function (Purpose)
User auto color calibration (color balance
adjustment) Inhibit/Allow setting
(copy mode)
Section
Operation/Procedure
1) Enter the set value with 10 keys.
1) Press [OK]/[START] key.
The selected set content is saved.
Item Display Content Range
1 (0:YES, 1:NO)
1 Control allowed
0 - 1
0 Control inhibited
U.S.A 1 (CE not supported) EUROPE 0 (CE supported)
CANADA 1 (CE not supported) U.K. 0 (CE supported)
INCH 1 (CE not supported) AUS. 0 (CE supported)
JAPAN 1 (CE not supported) AB_A 0 (CE supported)
AB_B 1 (CE not supported) CHINA 0 (CE supported)
Item Display Contents Range
1
TROUBLE
MEMORY
MODE
0
Only once display. If the trouble is
the same as the current one, the
trouble is not saved.
0 - 1
1
Anytime display. Even if the trouble
is the same as the current one, the
trouble is saved.
Item Display Content
Setting
range
1
M LIFE OVER
(0: CONTINUE
1: STOP)
0
Print Enable/Disable setting
when the maintenance timing is
over (Print Continue)
0
1
Print Enable/Disable setting
when the maintenance timing is
over (Print Stop)
Item Display Contents Range
1ACC
1 ACC is allowed.
0 - 1
0 ACC is permitted.