MX-C250 FIRMWARE UPDATE 8 – 2
1.1. Firmware update procedure from the USB memory
The firmware update executes by SIM49-01.
1) Insert the media or USB memory which stores the firmware into
the main unit. (Use the USB I/F of the operation panel section.)
2) Enter the SIM49-01.
Select the firmware file to be updated with [up] or [down] key.
The displayed firmware file is changed depending on the files in
the USB thumb drive.
* When there is no firmware file in the USB memory, “No file
detected” message is displayed.
* The displayed firmware file is changed depending on the
files in the USB thumb drive.
3) Select the file and press [OK] button or [Start] button. Then, the
current version and the new version are displayed.
4) Press [OK] button or [Start] button. Then, the machine is
restarted and the download of the firmware file starts.
* At this moment, do not disconnect the USB memory.
5) After downloading the firmware file, the upgrading starts.
* At this moment, do not disconnect the USB memory.
6) When the upgrading is finished, the upgrading result is dis-
played.
When the upgrading is finished correctly, the message shown in
the figure is displayed.
When the upgrading is failed, the defective part and the error
code are displayed.
To Next Page
Loading...
Need help?
General
