3 Flex, fan, and align the paper edges before loading.
4 Load the paper stack with the printable side faceup.
• For one‑sided printing, load letterhead faceup with the header toward the front of the tray.
• For two‑sided printing, load letterhead facedown with the header toward the back of the tray.
• Do not slide paper into the tray.
• Make sure that the stack height is below the maximum paper fill indicator. Overfilling may cause paper
jams.
5 Insert the tray.
If necessary, set the paper size and type to match the paper loaded in the tray.
Loading the manual feeder
1 Adjust the edge guides to match the width of the paper that you are loading.
Note: Make sure that the guides fit snugly against the paper, but not too tight as to cause the paper to
buckle.
Set up, install, and configure 45
To Next Page
Loading...
