Sharp MX-C358F

Menu item Description
Date and Time
Configure
Current Date and Time
Manually Set Date and Time
Date Format (MM‑DD‑YYYY*)
Time Format (12 hour A.M./P.M.*)
Time Zone
UTC (GMT)
Oset
DST Start
DST End
DST
Oset
Network Time Protocol
Enable NTP (On*)
NTP Server
Enable Authentication (None*)
Key ID
Password
Configure the printer date and time and network time protocol.
Notes:
• MM‑DD‑YYYY is the U.S. factory default setting. DD-MM-
YYYY is the international factory default setting.
• UTC (GMT) Oset, DST Start, DST End, and DST Oset
appear only when Time Zone is set to (UTC+user)
Custom.
• Key ID and Password appear only when Enable
Authentication is set to MD5 key.
Paper Sizes
U.S.*
Metric
Specify the unit of measurement for paper sizes.
Note: The country or region selected in the initial setup
wizard determines the initial paper size setting.
Screen Brightness
20–100% (100*)
Adjust the brightness of the display.
Flash Drive Access
Disabled
Enabled*
Enable access to the flash drive.
Allow Background Removal
O
On*
Specify whether background removal is allowed.
Allow Custom Job scans
O
On*
Specify whether the Custom Job Scanning setting appears for
copy, scan, and fax.
Note: This menu item appears only when a hard disk or an
intelligent storage drive is installed.
One Page Flatbed Scanning
O*
On
Set the printer to scan any type of job involving the scanner
glass as a single page.
Note: The printer returns to the home screen after
performing a single flatbed scan instead of displaying
prompts.
Note: An asterisk (*) next to a value indicates the factory default setting.
Use printer menus 94