9
INSTALLING THE PRINTER
DRIVER
To install the printer driver, follow the appropriate procedure in this section
depending on whether the machine is connected to a network or connected by
USB cable.
☞
WHEN THE MACHINE WILL BE CONNECTED WITH A USB CABLE (page 21)
WHEN THE MACHINE IS CONNECTED TO A
NETWORK
This section explains how to install the printer driver when the machine is
connected to a Windows network (TCP/IP network).
Supported operating systems: Windows 98/Me/NT 4.0
*
/2000
*
/XP
*
/
Server 2003
*
/Vista
*
/Server 2008
*
/7
*
* Administrator's rights are required to install the software.
•
To install the PPD driver when Windows 98/Me/NT 4.0 is used, see "USING
THE STANDARD WINDOWS PS PRINTER DRIVER (Windows 98/Me/NT 4.0)"
(page 32) and install the driver using the Add Printer Wizard.
• To use the machine as a network printer in Windows NT 4.0, "TCP/IP
Protocol" must be installed on your computer. If this is not installed, see
Windows NT 4.0 Help to install "TCP/IP Protocol".
• To print to the machine over the Internet using the IPP function when
the machine is installed in a remote location, or to print using the SSL
(encrypted communication) function, see "Printing using the IPP
function and the SSL function" (page 18) and install the printer driver.
• If the machine is connected to an IPv6-only network, the software
cannot be installed by detecting or specifying the machine's address
from the installer.
!mxc400P_us_ins.book 9 ページ ２００９年１０月５日 月曜日 午後２時２７分
To Next Page
Loading...
Need help?
General
