Sharp MX-M266N

FIRMWARE & PRINT DRIVER REVISION
SHARP
28
43
Fuser Setting & Adjustment
20
Fuser temperature. correction for low
temperature & humidity (Sim43-1)
22
Fuser temperature. correction for low
temperature & humidity (Sim43-3)
44
Process Control Data
1
Process control mode setting
9
Process control operation 1 data display
14
Temp.& humidity output data
43
DV unit identification information display
46
Copy & Image Density Adjustment
2
B/W copy density adjustment
4
Colour scanner density adjustment
5
B/W scanner density adjustment
8
Colour scanner balance adjustment RGB
9
SPF exposure adjustment
19
B/W auto exposure mode setup
30
Resolution adjust (sub-scan – copy mode)
32
Document background density adjust.
37
B/W image create adjustment
39
Fax Image send sharpness adjustment
40
Fax mode exposure adjust (All modes)
41
Fax mode exposure adjust (Normal)
42
Fax mode exposure adjust (Fine Text)
43
Fax mode exposure adjust (Super Fine)
44
Fax mode exposure adjust (Ultra Fine)
45
Fax mode exposure adjustment (600dpi)
47
JPEG compression rate setting
60
Sharpness adjustment (colour auto mode)
61
Area separation recognition setting
62
ACS operating condition setting
63
Copy low density adjustment
48
Magnification & Motor Adjustment
1
Magnification ratio adjustment (Main & Sub
scan)
5
Magnification ratio adjustment (Sub scan
only)
49
Firmware Upgrade
1
Firmware Upgrade Program
3
E Manual Update Program (Japan)
5
Watermark Update Program
50
Image Position Adjustment
1
Lead edge/copy position adjustment
5
Printer lead edge adjustment (sub scan)
6
SPF Lead edge/copy position adjustment
7
SPF Lead edge/copy adjustment value
10
Print off-centre deviation adjustment.
12
Original centre deviation adjustment.
27
Image loss adjustment (Fax/Scanner)
28
Service adjustment (OC/SPF position)
51
Resist Roller Adjustment
1
Transfer current ON timing adjustment
2
Resist roller adjustment
9
Separation voltage ON/OFF timing
adjustment
53
Document Feeder Adjustment
6
SPF document tray size adjustment
7
SPF document tray size adjustment value
set.
8
SPF scanning position adjustment
9
SPF dirt detection setting
10
SPF dirt detection execution
55
MFP Data Setting
1
Engine soft switch setting
2
Scanner soft switch setting
3
Controller soft switch setting:-
SW1-5
Auto clear function before copy
job execution:-
0 =Disabled, 1 = Enabled
SW3-6
Process mixed original size
printing for duplex mode:-
0 =Disabled, 1 = Enabled
SW3-7
HP Compatibility Mode:-
0 =Disabled, 1 = Enabled
SW6-1
Ethernet Speed Auto
negotiation:-
0 = Enabled, 1 = Disabled
SW6-2
Ethernet Link Speed:-
0 = 100Base TX, 1 = 10Base T
SW6-3
Ethernet Duplex Mode:-
0 = Full, 1 = Half
SW6-4
Ethernet 100/1000 Link Speed:-
0 = 100Base TX, 1 = 1000Base T
SW9-5
Maintenance notification setting
by Printer MIB:-
0 = Enabled, 1 = Disabled