Sharp MX-M266N

SHARP
TEST SIMULATION
29
55
MFP Data Setting
3
Controller soft switch setting:-
SW17-3
A3 / Postcard Counter Mode
0 = Disabled, 1 = Enabled
SW18-6
Hide Device Counter Clear
(SIM24-6 to 24-15)
0 = Hide, 1 = Display
SW22-5
Display toner remaining status:-
0= Disabled, 1 = Enabled/Display
SW24-7
Continuous print mode for OSA
(job queuing for EAM):-
0 = Job Queue Disabled
1 = Job Queue Enabled
SW25-7
Custom Envelope size (Printer).
0 = Disabled, 1 = Enabled
SW27-8
Retain Scan to Desktop
destination for a certain period
after a scan operation.
0 = Disabled (Default)
1 = Enabled
SW28-3
Single Email alert notification for
customer.
0 = Disabled (Default)
1 = Enabled
SW28-4
Envelop mode – automatically
change to size tab screen.
0 = Disabled, 1 = Enabled
SW32-2
Frequency to obtain remaining
toner information using MIB
0 = Every 25% (Default)
1 = Every 5%
10
Special Stamp setting (Taiwan only)
56
MFP Data Import & Export
1
Transfer data execute (MFP/SD Card/SRAM
& EEPROM)
2
Export/Import EEPROM/SD Card & HDD
data
3
Document filing data backup to USB
4
Job log data backup to USB
5
Export Adjustment & Settings data to USB
6
Output Jam/Trouble data
7
Export Syslog data to USB
11
Save SD card data to HDD temporarily
12
Copy SD card data saved temporarily on
HDD to machine
60
Memory Operation & Test
1
SDRAM read/write test (MFP PWB)
61
LSU Writing Adjustment/Test
1
LSU test (Polygon & BD detection check)
3
LSU power auto setup
62
HDD Operation & Test
1
HDD/SD Card format
2
HDD partial read/write check
3
HDD read/write check (all areas)
6
Smart (HDD) self diagnostic test
7
Smart (HDD) self diagnostic error log
8
HDD/SD Card format (excluding system &
operation manual area)
10
Job completion list deletion (with job log)
11
Document filing data deletion
12
Enable/disable auto format for HDD trouble
13
HDD format (manual area only)
14
Delete document filing management data
63
CCD Operation & Adjustment
1
Shading correction data display
2
Shading correction execution (force)
3
CCD gamma & colour correction adjust.
4
SIT chart patch density list display
5
CCD gamma & colour correction reset.
64
Self Test Print
2
Test print (B/W mode)
4
Printer self print test
5
Printer self print test (PCL)
6
Printer self pint test (PS)
65
LCD Operation & Adjustment
1
LCD touch panel adjustment
2
LCD touch panel adjustment result display
5
Operation panel key input test
66
Fax Control Settings & Adjustments
1
Fax Soft SW setting
2
Country code default set (Fax)
3
Fax PWB controller memory check
4
Fax signal line check (Max level)
5
Fax signal line check (Soft SW setting level)
6
Fax list print (confidential registration)
7
Fax memory printout (all data)
8
Fax sound message setup
9
Fax signal line check (Soft SW setting)
10
Fax all memory clear