MANUAL FINISHING
59
BASE SCREEN OF MANUAL FINISHING MODE
4
Load paper into the upper or lower
tray.
The paper orientation varies depending on the manual
finishing function.
► PAPER LOADING ORIENTATION
(page 60)
• Up to 200 sheets of paper can be loaded into each of the upper and lower trays.
• Insert the paper along the guides all the way into the tray.
• If the guide width is not correctly adjusted to match the paper width, paper may be jammed, skewed, or crease. Adjust
the paper guides to fit the width of the paper.
5
Select the appropriate finishing
method and change the paper tray or
output tray as required.
6
Tap the [Start] key to begin manual finishing.
Shows the selected
paper and output trays.
Selects an output tray for
finished paper.
Staples each set of
output.
Selects a staple position.
Staples the centre of the booklet and
folds the booklet along the centre.
Trims the excessive parts of booklet
folded along the centre.
Performs paper folding.
Selects the type of
folding.
Punches holes in paper.
Starts finishing.
Resets all settings.
Sets the number of copies
for output and the number of
sheets per set.
Selects a paper tray for
finishing.
Tap the [Type and Size] key
to set the paper type and
paper size.
To Next Page
Loading...
Need help?
General
