Sharp Plasmacluster FP-N60CX User Manual

OPERATION
MAIN UNIT OPERATION
DETERMINING THE BASE IMPURITY RATE
For the first 30 seconds after the power plug is inserted into the wall outlet, the unit
will check the conditions of the air. If operation is set to ON during this time, the
CLEAN-SIGN LIGHT will alternately flash in green, orange and red.
The unit will start operating when the MODE-ON / OFF Button is pressed.
To change operating modes, press the MODE-ON/OFF Button until the desired control
is activated.
Plasmacluster Indicator Light
Main Unit Controls
E-12
MODE-ON/OFF Button
• AUTO
• SILENT
• MEDIUM
• HIGH
• MAX
• POLLEN
AUTO operation
The fan speed is automati-
cally switched (HIGH, ME-
DIUM, SILENT) depending
on the amount of impurities
in the air. The sensors detect
the impurities for efficient air
purification.
SILENT operation
The unit will operate quietly
using minimal air intake.
Stop
POLLEN mode operation
The unit will operate at High fan
speed for 10 minutes, then will al-
ternate between MEDIUM and
HIGH.
10 minutes: High fan speed
20 minutes: Medium fan speed
20 minutes: High fan speed
MEDIUM to MAX operation
The unit will operate at a fan
speed of MEDIUM, HIGH or MAX.
Plasmacluster
AUTO
SILENT
MED
HIGH
MAX
POLLEN
h
OFF TIMER
FILTER
CLEAN-SIGN

Sharp Plasmacluster FP-N60CX Specifications

General

Brand	Sharp
Model	Plasmacluster FP-N60CX
Category	Air Cleaner
Language	English